Aluminium suspension levers reduce car weight without losing strength, but many people consider them to be non-repairable.

It is considered that in case of failure of individual components of aluminum lever, is it Hob or ball bearing, the full lever assembly and accord headlights should be replaced. This stereotype was formed due to the low hardness of aluminum. Many masters at overpress are simply afraid to damage the casing or housing.

In fact, everything is not as difficult as it might seem at first glance. First of all it is necessary to ensure the full and uniform adherence of the lever to presses or press surface. Ideally, it is better to use the special puller that is offered by some component manufacturers.

Attention! In no case you can use a hammer to drive out Hob. Pulse loads may lead to a resolution of the lever.